As Shown in the following figure, the switch configuration information is as follows. Which of the following statement about the network and configuration is/are true?
Router A
aaa
local-user test password cipher test local-user test service-type ppp
#
interface Serial1/0/0 link-protocol ppp
ppp authentication-mode chap
ppp pap local-user test1 password cipher test1
ip address 10.0.12.1 255.255.255.0
#
Router B
aaa
local-user test1 password cipher test1 local-user test1 service-type ppp
#
interface Serial1/0/0 link-protocol ppp
ppp authentication-mode pap
ppp chap user test
ppp chap password cipher test
ip address 10.0.12.12 255.255.255.0
As shown in Figure, Host A and Host B cannot communicate with each other?
As Shown in the figure, host A and host B cannot communicate with each other?
On the network shown in the figure, when planning traffic, the network administrator requires that the data packet sent from host A to host B pass through G0/0/3 on the router, and the packets sent from host B to host A pass through G0/0/4 on the router, which of the following command can be used to meed this requirement?
The LACP Priority is shown in the figure. Switch A and Switch B adopt link aggregation in LACP mode, All interfaces are added to link aggregation group (LAG), and the maximum number of active port is set to 3.Which port of switch A is not an active port?