Use High-Quality Fortinet FCSS_SDW_AR-7.6 Dumps- Try Free Demo

Question 1

(You are configuring SD-WAN to load balance network traffic and you want to take into account the link quality.

Which two facts should you consider? Choose two answers.)

AWhen applicable, FortiGate load balances the traffic through all members that meet the SLA target.

BYou can select the best quality strategy and allow SD-WAN load balancing.

CYou can select the lowest cost service level agreement (SLA) strategy and allow SD-WAN load balancing.

DThe best quality strategy supports only the round-robin hash mode.

Question 2

Which two statements correctly describe what happens when traffic matches the implicit SD-WAN rule? (Choose two.)

AThe session information output displays no SD-WAN service id.

BTraffic is load balanced using the algorithm set for the v4-ecmp-mode setting.

CThe traffic is distributed, regardless of weight, through all available static routes.

DTraffic does not match any of the entries in the policy route table.

EFortiGate flags the session with may_dirty and vwl_def ault.

Question 3

Refer to the exhibits.

The exhibits show two IPsec templates to define Branch IPsec 1 and Branch_IPsec_2. Each template defines a VPN tunnel. The error message that FortiManager displayed when the administrator tried to assign the second template to the FortiGate device is also shown.

Which statement best describes the cause of the issue?

AYou can assign only one template with a tunnel type of static to each FortiGate device.

BYou can assign only one IPsec template to each FortiGate device.

CYou should review the branch1_fgt configuration for configured tunnels in the rootVDOM.

DYou should use the same outgoing interface of both templates.

Question 4

Refer to the exhibit, which shows the SD-WAN rule status and configuration.

Based on the exhibit, which change in the measured latency will first make HUB1-VPN3 the new preferred member?

AWhen HUB1-VPN3 has a lower latency than HUB1-VPN1 and HUB1-VPN2

BWhen HUB1-VPN3 has a latency of 80 ms

CWhen HUB1-VPN3 has a latency of 90 ms

DWhen HUB1-VPN1 has a latency of 200 ms

Question 5

(You configure the overlay tunnels for an SD-WAN hub-and-spoke topology defined with IPsec tunnels, BGP on loopback, and dynamic BGP.

Which are two recommended IPsec settings for this topology? Choose two answers.)

AOn the spoke, set the parameter net-device to enable.

BOn the spoke, configure the parameter localid.

COn the hub, set the parameter mode-cfg to enable.

DOn the hub, set the tunnel type to static.

Unlock All Features of Fortinet FCSS_SDW_AR-7.6 Dumps Software

Just have a look at the best and updated features of our FCSS_SDW_AR-7.6 dumps which are described in detail in the following tabs. We are very confident that you will get the best deal on this platform.

Select Question
Types you want

Set your desired
pass percentage

Allocate Time
(Hours: Minutes)

Create Multiple
Practice test with
limited questions

Customer
Support

Latest Success Metrics For actual FCSS_SDW_AR-7.6 Exam

This is the best time to verify your skills and accelerate your career. Check out last week's results, more than 90% of students passed their exam with good scores. You may be the Next successful Candidate.

95%

Average Passing Scores in final Exam

91%

Exactly Same Questions from these dumps

90%

Customers Passed Fortinet FCSS_SDW_AR-7.6 exam