Get VMware 2V0-41.24 Exam Practice Questions - Real and Updated

Answer : D

A Service interface on the Tier-0 Gateway is required to make NSX Edge Services, such as NAT or load balancing, available to a VM on a VLAN-backed logical switch. The Service interface allows the Tier-0 Gateway to connect directly to the VLAN-backed network, enabling Edge Services to interact with VMs on that network.

Answer : B

The insertion point for East-West network introspection in NSX is at the Guest VM vNIC (virtual Network Interface Card). By inspecting traffic at the vNIC level, NSX can monitor and apply security policies to traffic between virtual machines (East-West traffic) within the same network segment or data center, providing detailed security controls for VM-to-VM communication.

Answer : D

To activate Malware Prevention on the NSX Application Platform, the steps are:

In the NSX Manager UI, select System and in the Configuration section, select NSX Application Platform.

Navigate to the Features section, locate the NSX Malware Prevention feature card, and click Activate or anywhere in the card.

In the NSX Malware Prevention activation window, select one of the available cloud regions from which you can access the NSX Advanced Threat Prevention cloud service.

Click Run Prechecks. This precheck process can take some time as the system validates that the minimum license requirement is met and that it is eligible for use with the NSX Advanced Threat Prevention cloud service. The system also validates that the selected cloud region is reachable.

Click Activate.This step can take some time1. Therefore, the correct answer is D. The other options are incorrect because they involve activating or deploying NSX Network Detection and Response, which is a different feature from Malware Prevention.Reference:Activate NSX Malware Prevention

Answer : D

If Distributed Firewall Rule hit counts are not being logged, it is likely because Distributed Firewall Rule logging is not enabled. For hit counts to appear in the logs, logging must be explicitly enabled on each firewall rule where tracking is required. Without enabling logging at the rule level, no hit count information will be recorded in syslog.

Answer : B

Using a Transport Node Profile allows the administrator to apply configuration changes, such as specifying an NTP server, across multiple Edge Transport Nodes efficiently. This method is scalable and avoids the need for manual configuration on each individual node. Once the Transport Node Profile is updated, the configuration can be pushed to all associated nodes.