Use High-Quality Fortinet NSE8_812 Dumps- Try Free Demo

A customer has FortiAP devices in three branch offices managed from a FortiGate in the HQ. Each FortiAP is connected to a dedicated management VLAN.

The customer wants the users connected to the FortiAP SSIDs to use the branch local internet connection, but each branch uses a different VLAN ID for the bridge. HQ users travel to different branches and connect to the same SSID.

Which configuration option will solve this requirement?

ASet each FortiAP to a wtp-group and use set vlan-pooling wtp-group on the VAP configuration with the corresponding VLAN ID configuration for each group.

BSet a FortiAuthenticator for 802.1x authentication with the Tunnel-Type attribute set to VLAN and use set dynamic-vlan enable on the VAP configuration.

CUse set vlan-pooling round-robin on the VAP configuration with the corresponding vlan-pool.

DUse set vlan-pooling hash on the VAP configuration with the corresponding vlan-pool.

Question 2

Refer to the exhibits.

An administrator has configured a FortiGate and Forti Authenticator for two-factor authentication with FortiToken push notifications for their SSL VPN login. Upon initial review of the setup, the administrator has discovered that the customers can manually type in their two-factor code and authenticate but push notifications do not work

Based on the information given in the exhibits, what must be done to fix this?

AOn FG-1 port1, the ftm access protocol must be enabled.

BFAC-1 must have an internet routable IP address for push notifications.

COn FG-1 CLI, the ftm-push server setting must point to 100.64.141.

DOn FAC-1, the FortiToken public IP setting must point to 100.64.1 41

Question 3

Refer to the exhibit, which shows an SD-WAN configuration.

You configured the SD-WAN from Branch1 to the HUB and enabled packet duplication. You later notice that the traffic is not being duplicated. In this scenario, what is causing this problem?

AThere is a mismatch in the FortiOS version between Branch1 and HUB.

BTraffic cannot be duplicated over multiple zones.

CPacket duplication is not enabled on the HUB side.

DPacket duplication did not occur because an interface is out of SLA.

Question 4

Refer to the exhibit.

Given the exhibit, which two statements about FortiGate FGSP HA cluster behavior are correct? (Choose two.)

AYou can run FortiGate Virtual Router Redundancy Protocol (VRRP) high availability in addition to FGSP simultaneously.

BSession synchronization occurs over Layer 3 by default, and if unavailable it will then try Layer 2.

CYou can selectively synchronize only specific sessions between FGSP cluster members.

DCluster members will upgrade one at a time and failover during firmware upgrades.

Question 5

Refer to the exhibit, which shows a Branch1 configuration and routing table.

In the SD-WAN implicit rule, you do not want the traffic load balance for the overlay interface when all members are available.

In this scenario, which configuration change will meet this requirement?

AChange the load-balance-mode to source-ip-based.

BCreate a new static route with the internet sdwan-zone only

CConfigure the cost in each overlay member to 10.

DConfigure the priority in each overlay member to 10.

Unlock All Features of Fortinet NSE8_812 Dumps Software

Just have a look at the best and updated features of our NSE8_812 dumps which are described in detail in the following tabs. We are very confident that you will get the best deal on this platform.

Select Question
Types you want

Set your desired
pass percentage

Allocate Time
(Hours: Minutes)

Create Multiple
Practice test with
limited questions

Customer
Support

Latest Success Metrics For actual NSE8_812 Exam

This is the best time to verify your skills and accelerate your career. Check out last week's results, more than 90% of students passed their exam with good scores. You may be the Next successful Candidate.

95%

Average Passing Scores in final Exam

91%

Exactly Same Questions from these dumps

90%

Customers Passed Fortinet NSE8_812 exam