Get VMware 2V0-41.23 Exam Dumps

Answer : A, B, D

According to the VMware NSX Documentation, these are three of the capabilities of Network Topology, which is a graphical representation of your network infrastructure in NSX:

Display how the different NSX components are interconnected: You can use Network Topology to view how your segments, gateways, routers, firewalls, load balancers, VPNs, and other NSX components are connected and configured in your network.

Display the uplink configured on the Tier-0 Gateways: You can use Network Topology to view the uplink interface and segment that connect your tier-0 gateways to your physical network. You can also view the VLAN ID and IP address of the uplink interface.

Display the VMs connected to Segments: You can use Network Topology to view the VMs that are attached to your segments. You can also view the IP address and MAC address of each VM.

Answer : D

A service interface is a logical interface on a tier-0 gateway that connects to a VLAN logical switch and provides NSX Edge services to the VMs on that switch.A service interface is required for services such as load balancing, VPN, NAT, and DHCP1. A downlink interface is used to connect a tier-0 gateway to a tier-1 gateway or an overlay logical switch. A VLAN uplink is used to connect a tier-0 gateway to the physical network.A loopback router port is used to assign an IP address to the tier-0 gateway for routing protocols or firewall rules2...

Answer : C, D

The NSX Application Platform Deployment features are divided into three form factors: Evaluation, Standard, and Advanced.Each form factor determines which NSX features can be activated or installed on the platform1.The Evaluation form factor supports only NSX Intelligence, which provides network visibility and analytics for NSX-T environments2.The Standard form factor supports both NSX Intelligence and NSX Network Detection and Response, which provides network threat detection and response capabilities for NSX-T environments3.The Advanced form factor supports all four features: NSX Intelligence, NSX Network Detection and Response, NSX Malware Prevention, and NSX Metrics1.

Answer : B, C, F

ccording to the VMware NSX Documentation, these are the three parameters that must match in order to establish an OSPF neighbor relationship with an upstream router on a tier-0 gateway:

MTU of the Uplink: The maximum transmission unit (MTU) of the uplink interface must match the MTU of the upstream router interface. Otherwise, OSPF packets may be fragmented or dropped, causing neighbor adjacency issues.

Subnet mask: The subnet mask of the uplink interface must match the subnet mask of the upstream router interface. Otherwise, OSPF packets may not reach the correct destination or be rejected by the upstream router.

Area ID: The area ID of the uplink interface must match the area ID of the upstream router interface. Otherwise, OSPF packets may be ignored or discarded by the upstream router.

Answer : B, E

According to the VMware NSX Documentation, these are two of the use cases for Distributed Intrusion Detection, which is a feature of NSX Network Detection and Response:

Quarantine workloads based on vulnerabilities: You can use Distributed Intrusion Detection to detect vulnerabilities in your workloads and apply quarantine actions to isolate them from the network until they are remediated.

Identify security vulnerabilities in the workloads: You can use Distributed Intrusion Detection to scan your workloads for known vulnerabilities and generate reports that show the severity, impact, and remediation steps for each vulnerability.