Get NetApp NS0-521 Exam Practice Questions - Real and Updated

Answer : B

To restrict access to a newly created LUN to specific hosts, the administrator should configure the igroup (initiator group). An igroup is used to control which initiators (hosts) are allowed to access specific LUNs. This ensures that only authorized hosts can access the storage, enhancing security and access control.

For more details, refer to:

NetApp Documentation on iGroups (NetApp).

Answer : A, C

To configure an SVM to use NVMe/FC, the following steps are necessary:

Add the FC protocol: This step involves enabling the Fibre Channel protocol on the SVM, which is required to support NVMe over Fibre Channel.

Create an NVMe/FC LIF: Logical Interfaces (LIFs) must be created to handle NVMe traffic over the Fibre Channel network. These LIFs enable the NVMe namespace access to the host systems.

These steps ensure that the SVM is correctly set up to use NVMe/FC, allowing for efficient and high-performance access to NVMe storage.

For more information, refer to:

NetApp NVMe/FC Configuration

Answer : C

The recommended setting for using the NetApp ONTAP LUN fractional reserve is to set the space guarantee to 'volume'. This setting ensures that the required space for overwrites in the volume is reserved, preventing potential write failures when snapshot copies are created. This setup helps in maintaining the performance and reliability of the storage system by ensuring there is always enough space allocated for the LUN.

For further details, you can refer to:

NetApp Community Discussion on Fractional Reserve

NetApp Documentation on Space Management

Answer : A

To validate that the entire network path supports jumbo frames after an iSCSI implementation, you should perform a ping test from the host with fragmentation. This involves using the ping command with specific options to test jumbo frame support:

ping -M do -s 8972 <target_IP>

In this command:

-M do ensures the packets are not fragmented.

-s 8972 sets the packet size to 8972 bytes (9000 bytes MTU minus 28 bytes for the ICMP header).

By confirming that the large packets are successfully transmitted without fragmentation, you can validate that the network path, including switches and adapters, supports jumbo frames.

For more details, you can check:

NetApp Documentation - iSCSI Configuration and Best Practices (NetApp) (NetApp).

Answer : C

To verify that a modified FC port is usable after it has been repurposed from tape backup to FCP SAN, the command system node hardware unified-connect show should be used. This command checks the status and configuration of the unified connect hardware, ensuring that the port is correctly set up for the new function in the SAN environment.

For additional details, see:

NetApp Command Reference