Get Huawei H35-481_V2.0 Exam Dumps

Answer : A, B, C

In the data reconfiguration using the MAE-Deployment, the MOs gNodeBFuncrjon, gNBCULogicNode, and gNBDULogicNode are involved. These MOs are responsible for configuring the gNodeB functional parameters, the gNodeB CU logical nodes and the gNodeB DU logical nodes.

Answer : B

The UBBP board is added to the base station when it is reset, and you need to log in to the LMT again in order to access the new UBBP board. The UBBP board is used for configuration, monitoring, and maintenance of the base station.

https://www.gsma.com/futurenetworks/wiki/5g-implementation-guidelines/

5G Implementation Guidelines: NSA Option 3 - Future ... - GSMA

https://www.gsma.com/futurenetworks/wiki/5g-implementation-guidelines/

https://arxiv.org/pdf/2202.01032

Understanding O-RAN: Architecture, Interfaces, Algorithms, Security ...

https://arxiv.org/pdf/2202.01032

https://www.fcc.gov/file/18918/download

Report on Risks to 5G from Legacy Vulnerabilities and Best ...

https://www.fcc.gov/file/18918/download

According to Huawei's official documentation, when the UBBP (Universal Baseband Processing) board is added, the base station is reset and you need to log in to the LMT (Local Management Terminal) again. The addition of other boards (OUMPT, UPEU, UEIU) may not require a reset and re-login.

Answer : D

The Slot1 on both the BBU5900 and BBU3910 retains the same physical position. Slot1 is used for the O&M interface, and is used for communication between the BBU and the OSS. It supports the SFP/SFP+ optical modules for O&M communication.

Answer : A, C, D

In Non-standalone (NSA) networking, the downlink peak rate of a CPE is affected by various factors, such as the downlink transmit power of the NR base station, the CPE location, the quality of the radio channel, and the configuration of the network. -The downlink transmit power of the NR base station affects the signal strength received by the CPE and therefore can affect the peak rate achieved. -The CPE location in relation to the base station can affect the signal strength and quality of the radio channel. If the CPE is located farther away from the base station or in an area with high radio interference, it may result in a lower peak rate. -Downlink BLER of 3% or above can result in retransmission and thus lower peak rate. -Uplink transmit power of the CPE does not affect the downlink peak rate of CPE as it is only related to uplink transmission.

Answer : A

In Non-standalone (NSA) networking, X2 self-setup between a gNodeB and an eNodeB requires that the gNodeB and eNodeB be managed by the same OSS. Because gNodeB and eNodeB are managed by the same OSS, the OSS can configure the X2 self-setup parameters, such as the X2 self-setup switch, the X2 interface IP address, and the X2 self-setup trigger conditions. Only when the gNodeB and eNodeB are managed by the same OSS and configured with the same X2 self-setup parameters, the gNodeB and eNodeB can establish an X2 self-setup connection.